- Make sure this fitsby entering your model number.
- Strong self adhesive: The led strip lights has a stronge self adhesive so they stick very well on TVs, cars, cabinets and walls; Please test the led strip lights before installation, every roll lights has one connector to link with controller box, so they should be attached in parallel, not in series
- Colorful and durable: The infrared remote can adjust multiple colors, including rgb, white, 16 other colors and their brightness; With 6 dynamic modes (auto, flash, jump3, jump7, fade3, fade7) and 2 speed modes (quick, slow) by remote, you can make the light strip show varieties of different color changes; Use the DIY buttons to save 6 colors if you like
- Cuttable and linkable: Can be cut every 3 LEDs along the cutting marks if you don't need such a long lights or you could extral connectors to extend the lights for your bedroom, TV, desk, computer indoor
- Remote contol: You can use the infrared remote control to remotely control the light strip to suit the mood of the room easily; You can set it according to different scenes until you are satisfied
- Widely use: The led lights are suitable for bedroom, kitchen, cabinet, car, living room, party or wedding
Daybetter led strip lights, light up your life
The Package contains: 2 rolls 16.4ft rgb led strip lights, 12 volt power supply, ir box controller, 44 key remote
LED strip lights kit
32.8Ft Led Strip Lights
44 Keys IR Controller Remote
- Please clean the surface before stick on the strip and make sure that the paste is successful by one time, otherwise, the stickiness will become weak after repeated use, and you need to add back glue again
- Please don’t stick the lights to the metal surface that conductive, it may cause a short-circuit on the strip lights
- Don’t let them on the spool when you testing them for more than 2 minutes, they need to dissipating heat
- The ventilation must be ensured, these lights need an excessive amount of airflow for cooling
Please notice to connect the 4pin connectors of the controller box arrow to the positive of lights; If not, it will don’t work.
Test the lights before installation
Please confirm your connection is correct, below is some steps need to notice:
- Connect the 4pin connectors of the controller box arrow to the positive of lights.
- Make sure the lights are connected, and the power light up green bulb.
- Pull out the transparent chip from the button of the IR remote.
- Use the IR remote turn on the lights (IR remote aim at the IR receiver).
About DIY function, Please follow the steps below：
Step 1: Turn on the lights. Press one of the RGB buttons. Step 2: Press the DIY1 button (the lights will change to white color for the first time). Step 3: If you need deeper red color, press and hold the red up button(at least 5 seconds), the longer you hold, the deeper red color you have. You can also press green and blue down, the changing will be more clearly. Step 4: Keep the color you just set by pressing the DIY1 button again. Step 5: Repeat the steps above to set the rest of five DIYs.
Adhesive is strong and lets you place, such as the back of TV, table, cabinet and window
TIP:the adhesive is very strong so use caution when using it on white walls or unfinished wood
Used for kitchen, they are stick well on cabinet and wall
Used for living room decoration for backlight, under desk, behind TV
The lights be used for bedroom, ceiling